Author Topic: TGB Blade 425 starting problem  (Read 2584 times)

nikkern

  • Guest
TGB Blade 425 starting problem
« on: July 16, 2014, 10:49:12 AM »
Hello.
 I have TGB 425 Blade ATV that will not start with the electric starter button. All it will do is make a clicking sound from the relay. I know the starter I fine, I have tested it. So is the fuse and the starter relay is new also and still nothing happens. The battery is new and charged, I have checked continuity of the wires and the brake switch. Has anyone had this problem?
Thank you for any ideas

harry

  • Administrator
  • Hero Member
  • *****
  • Posts: 829
  • Personal scooter consultant to the rich & famous
    • Whidbey Island Moped
Re: TGB Blade 425 starting problem
« Reply #1 on: July 17, 2014, 06:57:57 AM »
usually a clicking sound means low battery or bad connections.
check continuity  of the wires in the starting circuit .
 make sure the starter button is  making good contact when pressed.
good luck

oilyhans
i own a scooter shop  with rentals ,sales& racing parts.
i also appraise scooters for KBB.

2003 Vino classic stage 0.75
de-reged stock variator w/8g sliding weights.
1.5k rpm  springs
42mph
2005 veniceLX ~70cc~upjet~1.5k rpm springs & 7gr sliders
46mph
KeyWest de restricted~8gr slide

CyclePilot

  • Guest
Re: TGB Blade 425 starting problem- HELP!!
« Reply #2 on: October 29, 2014, 02:43:48 PM »
HELP!!

Hi all,

New to the forum but need your help..

My issue with my Outback 425c is that when I hit the starter button to use the atv I hear the starter but is "Free spinning" and not turning over the engine. My guess is that is not engaging the 'cluth' to turnover the flywheel and thus the engine... almost as if the started was spinning the "wrong way" (I don't think it is but is the best way I can describe it)


Is anybody else have this issue? can someone shine some light on this??

Any and all help is much appreciated!!