Author Topic: TGB Bullet RS50 problems with installing exhaust  (Read 1067 times)

Spaalmj

  • Guest
TGB Bullet RS50 problems with installing exhaust
« on: July 16, 2015, 04:54:06 AM »
Hi, yesterday I removed my muffler (?) to see if it had some sort of restrictions in it. As I could not find anything, I went on to try and re-install everything the way it previously had been. This is where the problems occured. I don't know how to screw these two screws (the other one is behind the pipe) properly in, and is there supposed to be something inbetween these two pipes? Do I need a penta screwdriver for these?

Thanks in advance,
Paal

harry

  • Administrator
  • Hero Member
  • *****
  • Posts: 829
  • Personal scooter consultant to the rich & famous
    • Whidbey Island Moped
Re: TGB Bullet RS50 problems with installing exhaust
« Reply #1 on: July 16, 2015, 05:42:22 AM »
go buy some new hex socket screws to replace the weird head ones
that are used by the factory......
most TGB's use a ring gasket between the head and the exhaust pipe
  i have them...if you can't find yours.

 oilyhans
i own a scooter shop  with rentals ,sales& racing parts.
i also appraise scooters for KBB.

2003 Vino classic stage 0.75
de-reged stock variator w/8g sliding weights.
1.5k rpm  springs
42mph
2005 veniceLX ~70cc~upjet~1.5k rpm springs & 7gr sliders
46mph
KeyWest de restricted~8gr slide