one of the other 50cc scooters that i am a dealer for included a
chart of each scooter they sold with approximately 5hp
at the output shaft and 3hp at the wheel also. kinda standard i guess
will you be milling the cylinder , head or piston?
porting?
or just bolt on and test? perhaps bolt on test and then mill etc & test?
it would be interesting to compare the standard vs machined parts there too .
lots of pipes out there and so little time .. turbokit , mrp brand , polini , molissi
check my site
whidbeyparts.com & use the search
for hyosung,tgb or morini and you will find stuff
oilyhans
i own a scooter shop with rentals ,sales& racing parts.
i also appraise scooters for KBB.
2003 Vino classic stage 0.75
de-reged stock variator w/8g sliding weights.
1.5k rpm springs
42mph
2005 veniceLX ~70cc~upjet~1.5k rpm springs & 7gr sliders
46mph
KeyWest de restricted~8gr slide